Festo CMMO-ST-C5-1-LKP, Original Instructions Manual

Page: 83 / 183

B Reference paramete
Festo – GDCP-CMMO-ST-LK-C-HP-EN – 2017-05b – English 83
B Reference paramete
B.1 General FHPP parameter structure
The motor controller includes a parameter set with the following structure.
Group PNU range Description Page
Device data 100 … 199 Device identification and device-specific settings, e.g.
version numbers.
85
Diagnostics 200 … 299 Diagnostic events and diagnostic memory. Fault num­
bers, timestamp, incoming/outgoing event.
86
Process data 300 … 399 Current setpoint and actual values, local digital in­
puts and outputs, e.g. status data.
87
Record list 400 … 499 A record includes all the setpoint value parameters
required for a positioning procedure.
88
Project data 500 … 599 Fundamental project settings, e.g. maximum speed,
acceleration, deceleration, project zero point offset.
These parameters are the basis for the record list.
90
Factor group 600 … 699 Parameters for unit conversion. 92
Axis data: electric
drives 1
1000 … 1099 All axis-specific parameters for electric drives, e.g.
gear ratio, feed constant, reference parameters.
93
Tab. B.1 FHPP parameter structure