DNCI−...
Festo DNCI−... 0610a English
30
Replacing the sensor
1. Unscrew the fastening screws.
2. Replace the sensor.
Note here the mechanical coding on the sensor housing and make sure that the
seal is seated correctly.
3. Screw the fastening screws in again.
The tightening torque is 0.6 Nm.
If required:
S
Order a wearing parts kit.
In this way you will prevent damage to the cylinder at a later stage.
S
Always send defective articles to Festo.
Explain the fault and the conditions of use in an accompanying letter.
S
Make sure that the product is overhauled only by our repair service.
The repair procedures require settings with very accurate adjustments.
Summary of Contents for 535411
Page 99: ...DNCI Festo DNCI 0610a 99...
