Festo CP-FB11-E 0112e English
16
3
Configuration
Caution
The node contains electrostatically sensitive compo-
nents. The node will be damaged if you touch the con-
tact surfaces of the plug connectors or if you do not
observe the regulations for handling electrostatically
sensitive components.
Proceed as follows when configuring:
1. Switch off the power supply.
2. Open the switch cover.
3. Use the rotary/DIL switches to set the following
(see section 4):
– Station number
– Field bus baud rate
– If desired: set compatibility.
4. Screw the switch cover tight again.
5. If the CP system is the first or last field bus slave, a
terminating resistor must be fitted (see section 2):
Warning
S
Check the measures required for putting your system
into a safe status in the event of an EMERGENCY
STOP.
Further information can be found in manual
P.BE-CP-FB11-E-.. .
Summary of Contents for 18227
Page 12: ...Festo CP FB11 E 0112e Deutsch 12...
Page 22: ...Festo CP FB11 E 0112e English 22...
