Ferroli TOP FAN Plus rem, Instruction Manual, Page: 7 / 16

7
USE - REMOTE CONTROL
Start / Stop ("On/Send" and "Off" buttons)
press the “On/Send” button to activate the fan coil unit and/or update the
information.
All selected and memorized functions will light up and appear; the unit
will operate according to the functions selected.
press " Off" button to stop the air conditioner.
All indicators on the unit will go out, and the control will display only the
current time.
If the unit does not stop, turn the control on (by pressing " Off" button)
and repeat the operation.
The unit will only emit a “beep”, when the signals are received correctly.
Selection of the operating mode ("Mode" button)
With this button the operating mode of the air conditioner can be
selected. By repeatedly pressing this button the available modes will
be selected in sequence. The choosen mode is shown as follows, while
the unit will acknowledge signal receipt with a confirming beep.
• Cool
• Heat
• Auto change-over
• Only fan
press “On/Send” to send the information to the thermostat.
The unit will only emit a “beep”, when the signals are received correctly.
Temperature setting (+ and - buttons)
pressing the Up + and DOWN - buttons will increase or decrease the
temperature from the previously set value.
The temperature can be set between 10°C and 35°C at 1 degree
intervals.
In cooling mode, if the temperature selected is higher than the room
temperature the unit will not start; the same applies for the heating
mode, if the selected temperature is lower than the room temperature.
press “On/Send” to send the information to the thermostat.
The unit will only emit a “beep”, when the signals are received correctly.
Fig. 1
Fig. 2
Fig. 3