IS3100Z Series - 4 Wheel IS - 61” & 72” Mower Deck
5
Roll Bar Assembly
Assemble the Retainer Pins
1. Unpack the roll bar and hardware from the box.
2. Assemble the foam ring (A, Figure 5) onto the
retainer pin (B).
3. Loop the snap end of the lanyard (C) through the
retainer pin handle and snap together.
4. Install the lanyard anchor (D) onto the lanyard.
5. Install the clevis pin (E) onto the loop end of the
lanyard as shown in Figure 5.
Figure 6. Assemble the Top Loop
A. Top Loop Tube
B. Plastic Cap
C. Rubber Stop
A
B
C
Frame
A
B
Figure 7. Installing Roll Bar
A. Upright Tubes (LH Side Shown)
B. 5/8-11 x 3 1/4” Bolts
C. Washers
D. 5/8” Hex Center Lock Nuts
C
B
C
D
C
A
Figure 5. Assemble the Retainer Pins
A. Foam Ring
B. Retainer Pin
C. Lanyard
D. Lanyard Anchor
E. Clevis Pin
A
B
C
D
E
Snap End
Loop End
Assemble the Top Loop
1. Install the plastic cap (B, Figure 6) into the end of the
top loop tube (A). Repeat for other end of tube.
2. Make sure the rubber stop (C) is properly seated
against the inside of the pivot mount. See Figure 6.
Install the Roll Bar
1. Make sure the roll bar sockets are clear of any
obstructions, wires, foreign objects, etc.
2. Install the Roll Bar upright tubes (A, Figure 7) to the
frame as shown in Figure 7. Loosely install the 5/8-
11 x 3 1/4” bolts(B), washers (C), and hex center lock
nuts (D).See insert.
IMPORTANT: The upright tube with the English
language decal must be installed on the left-hand side of
the unit with the decal facing forward. The upright tube
with the Spanish language decal must be installed on the
right-hand side of the unit with the decal facing forward.
See Figure 8 for proper upright tube orientation.
