Not for
Reproduction
29
3. Press the hydraulic deck lift button and then push the lock
lever towards the right to release the lock.
4. Release the hydraulic deck lift button and gravity will
lower the deck until the deck lift linkage comes to rest
against the cutting height adjustment pin.
To set the cutting height at 5" (12,7 cm):
1. While sitting in the operator’s seat, press the hydraulic
deck lift button with your foot until the deck locks into the
5" (12,7 cm) position.
2. Place the cutting height adjustment pin in any open
cutting height hole. The lift lock lever holds the mower
deck at 5" (12,7 cm) while cutting.
Foot Pedal Adjustment
The deck lift foot pedal can be adjusted to accommodate the
operator’s height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 37) from the pedal
mount tab (B).
37
2. Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the
proper orientation as shown in Figure 37.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan which can be
removed to provide better access to the mower deck.
1. Loosen and remove the retaining hardware (A, Figure 38)
that secures the floor pan to the frame of the unit.
38
2. Tilt the back end of the floor pan up and then remove it
from the unit.
3. To re-install the floor pan: Reverse the removal
procedure.
Suspension Adjustment
The shock assemblies (A, Figure 39) can be adjusted to allow
the operator to customize the ride according to the operator's
weight and/or operating conditions.
39
The front shock assemblies can be adjusted by changing the
spring's pre-load.
