8
© Ferno-Washington, Inc 234-0037-05 August 2009
Model 103 Combination Table
4 - seTUP
Setup
Follow the instructions in this section to prepare the table for use. All hardware is supplied.
4.2 attach Frame braces
Use a #2 Phillips screwdriver to attach the four frame
braces to the lower rails and corner posts using the
eight Phillips pan-head screws provided (Figure 2).
Frame Brace
Phillips
Pan-Head
Screw
Figure 2 - Attaching the Frame Braces
4.1 attach the lower rails
and Table ends
One Allen-head screw and two lock washers are
1.
threaded into each of the four table-end wheel
castings. Remove these parts from their shipping
positions using the 3/16" Allen wrench provided
with the table.
Insert the lower rails into the table-end corner
2.
castings (Figure 1). Verify that the holes for the
frame braces
and
table-ends are properly aligned
as follows:
The frame-brace mounting holes must face
○
straight upward as shown in Figure 1 (not at
an angle).
The holes at the ends of the lower-rails are
○
angled to properly align with the table-end
castings. After inserting the lower rails into
the table ends, verify that these holes are
visible in the table-end castings.
If the holes in the lower rail are not visible
○
inside the table-end castings OR if the
frame-brace holes are not facing straight
up, turn the lower rail end-for-end.
Verify that there are two lock washers on each of
3.
the four Allen-head mounting screws.
Secure the rails to the table ends using the 3/16"
4.
Allen wrench and four socket-head cap screws
provided (Figure 1 inset).
Lower Rail (2)
Frame-Brace
Mounting Hole (4)
Table End (2)
Figure 1 - Attaching the Lower Rails and Table Ends
Socket-Head
Cap Screw (4)
