Page 10
DUO
DUO
DUO
DUO
DUOX CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
DUO
DUO
DUO
DUO
DUOX CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
X CITYLINE KIT 3-24L
RESTORE DEFAULT VALUES:
Reset
JP1
lit when the camera is activated
Camera LEDS
M)
LEDS ON
Always Off
LEDS OFF
Line termination integrated into the amplifier for possible use.
JP2 :
IMPORTANT NOTE:
Camera focus
To adjust the camera’s image, see
ANNEX: Voice assisted configuration in button panels.
Instructions included with this equipment.
You can also set it by temporarily connecting a keypad (ref. 7439), or via the duox
programmer (ref. 3254) locally connected.
Download the manuals at: www.fermax.com.
-
Direct Video Duox Panels Programming Manual, cod. 97900.
- DUOX Programmer Manual ref 3254, cod. 97731.
1.- Reset amplifier: remove power.
2.- With the SW1 button pressed, power and maintain the SW1 button for 5 seconds. The
LED will blink quickly to indicate that button mapping has been restored.
RESET Mapping (call button code)
The DUOX amplifier has a ‘Reset’ function which can be used to restore programmed
default parameters.
There are two programmable lock-release activation times:
- Lock-release time set from the residence.
- Lock-release time set from the exit button (connected to the ‘BS’ and ‘-’ terminals).
Notes:
•
Values
:
- Lock-release time:
01..99 sec. (Default: 03).
- Exit button time:
00..99 sec. (Default: 06). Deactivated: 00.
Programming Lock Release Times
DUOX Amplifier Call:
•
Panels with an address "0" in each block allow for communication with telephones
when picked-up or with the monitors doing an auto-start with it and when the
communication lines are free. If you do not want this feature do not assign this
address to any panels. The monitors also have the option of an auto-start with
panel 1 in your block and panel 0 of the General Entrance.
•
The call is made to the home by pressing the corresponding button.
