6
EN
Immediately unplug the plug from the
mains electricity in the case that the cord
gets damaged and during maintenance.
Keep bystanders away.
Wear eye and ear protection.
During use the following points must be
considered:
• Do not remove any mechanical or electrical
protective provisions.
• Check whether all the protective provisions are
in place and have been attached correctly.
• Wear safety goggles during drilling.
• If you have long hair, be sure to wear hair
protection (hair net or cap). Long hair can
easily be caught in moving parts.
• Wear fitted clothing; tie buttons on sleeves.
• Do not hold any workpieces in your hands
when drilling. Always use a machine clamp or
another clamping tool.
• Protect workpieces and clamping tools on the
bench to prevent them from getting caught.
Fasten them yourself with screws or clamp
them to a machine clamp fastened to the table.
• Check whether the drill holder is tightened
properly.
• Check whether cable lead-throughs are okay.
• To remove drill chips only use hand brushes,
brushes, rubber wipers, chip hooks or similar aids.
• Do not carry out any cleaning or greasing work
while the machine is in operation.
• Always keep V-belts covered (so that your
hands cannot become caught).
• Only tighten the toothed ring drill holder by
means of the wrench.
• Never leave the wrench of the drill holder in the
drill holder! Before switching on the machine,
check whether the wrench really has been
removed!
• Do not use any drills which are damaged on
the shank.
• Drill is not suitable to use as press!
• If the mains cable is damaged, it may only be
replaced by a mains cable of the same type.
Immediately switch off the machine when:
• Interruption in the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply corre-
sponds to the voltage on the rating plate.
The machine is provided with a zero
voltage switch. After the tension drops
the machine will not start to run
automatically for safety reasons. The
machine must be switched on again.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
If the supply cord of this power tool is damaged, it
must be replaced by a specially prepared supply
cord available through the service organization.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm2. When using a cable
reel always unwind the reel completely.
Safety instructions for transportable drills
Drill safety warnings
a)
The drill must be secured.
A drill that is not
properly secured may move or tip over and
may result in personal injury.
b)
The workpiece must be clamped or secured
to the workpiece support. Do not drill
pieces that are too small to be clamped
securely.
Holding the workpiece by hand
during operation may result in personal injury.
c)
Do not wear gloves.
Gloves may be entangled
by the rotating parts or chips leading to
personal injury.
