Ferm
5
MOUNTING ACCESSORIES
Fig.B
Prior to mounting an accessory always unplug the
tool.
MOUNTING AND REMOVING CUTTERS
Only use cutters with a shaft diameter which
corresponds with the size of the collet. Only use cutters
which are suited for the maximum speed of the machine.
The cutter diameter should not exceed the maximum
diameter (see ‘Technical specifications’).
•
Press in the spindle lock (5) and turn the spring-
chuck nut (6) until it drops into the lock. Keep the
spindle lock pressed in as long as you are following
this procedure.
•
Use the open-end wrench to unscrew the spring-
chuck nut.
•
Place the cutter shaft in the collet.
•
Tighten the collet nut so that the cutter is locked
properly.
•
Open the collet nut when you want to replace a
cutter.
Wait until the machine has come to a complete
standstill and the cutter has cooled down before
replacing a cutter.
MOUNTING AND ADJUSTING THE
PARALLEL GUIDE
Fig.C
The parallel guide is a handy aid when working on
narrow workpieces.
•
Mount the parallel guide. Attach the guide rods (15)
on the frame (14) using the bolts (16).
•
Loosen the locking bolts (9) and slide the guide rods
in the openings (8).
•
Adjust the parallel guide to the desired guide
distance.
•
Tighten the locking bolts again.
MOUNTING THE GUIDE BUSH
Fig.D
The guide bush is a handy aid for cutting a pattern.
•
Mount the template guide (20) by using the screws
(17) on the cutter sole.
17
20
15
16
9 8 14
6
5
4
Ferm
