MOUNTING THE ADAPTER FOR DUST
EXTRACTION
Fig.E
Use the adapter for extracting dust.
•
Remove the spring-chuck nut as mentioned in ‘Fitting
and removing cutter bits’ (Fig. B).
•
Loosen the clamp screw (2) for the machine and
remove the machine from the base.
•
Remove the clamp screws for the parallel guide (9)
on the back of the machine.
•
Mount the adapter for vacuum cleaning (18) by using
the screws (17) on the cutter sole (7).
•
Place the clamp screws for the parallel guide back on
the cutter sole.
•
Place the machine back in the base and tighten the
clamp screw.
•
Place the spring chuck nut back on the machine.
•
Place the mouthpiece of a vacuum cleaner on the
outlet of the adapter.
Keep the outlet of the machine behind the machine
for a good view on the workpiece.
OPERATION
Always observe the safety instructions and
applicable regulations.
Hold the machine in rest position on the workpiece
when switching the machine on or off. The cutter in the
collet may damage the workpiece.
•
Clamp the workpiece and make sure that the
workpiece cannot slide from under the machine
during the cutting activities.
•
Hold the machine firmly and move it evenly over the
workpiece. Do not force the machine.
•
Only use cutters which do not show any signs of
wear. Worn cutters have a negative effect on the
efficiency of the machine.
•
Always switch off the machine first before removing
the plug from the wall socket.
ADJUSTING THE CUTTING DEPTH
Fig.F
The cutting depth can be adjusted in two ways.
Adjustment using the scale
•
Loosen the locking bolt of the depth stop (12).
•
Release clamping lever (3) and press the machine so
far down until the cutter touches the workpiece.
•
Tighten the clamping lever again.
•
Set the desired cutting depth using the graduated
scales (11) and then tighten the clamp screw.
Adjustment using the revolver- depth stop
The revolver-depth stop enables you to quickly choose
between three different cutting depths. These are also
determined by the adjustment of the depth scale (11).
•
Adjust the required cutting depth by the three
screws on the revolver-depth stop (10).
3
12
10
11
18
2
19
17
7
9
Ferm
10
9
Ferm
