Ferm MSM1034, Original Instructions Manual

Page: 10 / 52

EN
10 Ferm
Mounting the support bracket.
Mount the support bracket into the slot in the •
rear of the base.
Tighten the screw to secure the support •
bracket.
Installation of the machine on a workbench or
on the subframe.
This machine is a stationary machine and for
safety reasons must always be firmly installed and
not used for mobile applications.
You can install the machine in two ways:
a. As a stationary machine on a workbench. In
this case the machine must be secured to the
workbench with 4 bolts.
b. As a stationary machine on the subframe. In
this case the machine must be secured to the
subframe with 4 bolts and the subframe
anchored to the floor or to a floor plate with
dimensions of at least 1 square meter.
Guide fence insert
Fig. H, I, J
For safety reasons, this machine is equipped with
a guide fence insert
to be used when using the machine for sawing
straight cross-cuts.
For sawing straight cross-cuts, the guide •
fence insert must remain mounted on the
machine (fig. H).
For sawing mitre cuts, the guide fence insert •
must be removed from the machine as shown
(fig. H).
For sawing bevel cuts, the guide fence insert •
must be removed from the machine as shown
(fig. I+J).
Mounting and removing the saw blade
Fig. A+B
Do not use the machine without the
guard.
Mounting
Pull out the locking knob (3) and raise the saw •
head (12).
Loosen the bracket (29) by removing the •
screw (30).
Raise the guard (6). •
Keep the spindle lock button (7) pressed and •
loosen the bolt (19) using the spanner (20).
Remove the flanges (21 & 22). •
If necessary, clean the flanges (21 & 22). •
Mount the flange (22). •
Mount the saw blade (5). Make sure that the •
arrow on the saw blade points in the same
direction as the arrow on the saw head.
Mount the flange (21). •
Keep the spindle lock button (7) pressed and •
tighten the bolt (19) using the spanner (20).
Lower the guard (6). •
Mount the bracket (29) by tightening the screw •
(30).
Removing
Pull out the locking knob (3) and raise the saw •
head (12).
Loosen the bracket (29) by removing the •
screw (30).
Raise the guard (6). •
Keep the spindle lock button (7) pressed and •
loosen the bolt (19) using the spanner (20).
Remove the flange (21). •
Remove the saw blade (5). •
Mount the flange (21). •
Keep the spindle lock button (7) pressed and •
tighten the bolt (19) using the spanner (20).
Lower the guard (6). •
Mount the bracket (29) by tightening the screw •
(30).
Setting the mitre angle
Fig. C
The mitre angle is left/right variable between •
0° and 45°. The mitre angle can be read from
the scale (9).
Do not set the mitre angle during use.
Slacken the locking knob (8). •
Turn the saw table (13) to the required •
position.
Tighten the locking knob (8). •
Setting up the double sawing angle / mitring
Fig. D
Adjust the first angle as described for •
adjusting the saw angle (above).
Turn the knob (10) anticlockwise and then set •
the angle desired (you can read this off on the
back of the machine. Then tighten the knob
(10) again by turning it clockwise.