Ferm JSM1026, Original Instructions Manual

Page: 5 / 44

5
EN
NOISE AND VIBRATION
Sound pressure (Lpa) 70 dB(A) K=3 dB(A)
Acoustic power (Lwa) 81 dB(A) K=3 dB(A)
Vibration (wood) 3.33 m/s
2
K=1.5 m/s
2
Vibration (metal) 3.98 m/s
2
K=1.5 m/s
2
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 62841; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your jigsaw has been designed for sawing wood,
metal, plastics, ceramics, rubber, etc. to any
required size and in any required shape.
1. On/off switch
2. Lock off button
3. Saw blade holder
4. Saw shoe
ASSEMBLY
Before assembly, always switch off the
machine
The battery must be charged before firstuse.
Removing the battery from the machine
• Push the battery unlock buttons and pull the
battery out of the machine
Inserting the battery into the machine
Ensure that the exterior of the battery is clean and
dry before connecting to the charger or machine.
• Insert the battery (2) into the base of the
machine
• Push the battery further forward until it clicks
into place.
Charging the battery (with the charger)
• Plug the charger plug into an electrical outlet
and wait for a while. The LED indicator will
lighten up and show the charging status.
LED Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• Fully charging the 1.5Ah battery may take up
to 240 minutes.
• After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used
over a longer period of time it is best to
store
Mounting and removing the saw blade
Refer to the table below to select the required saw
blade.
Saw blade Material
Coarse Wood
Medium Wood
Fine Steel, aluminium, plastic
Very fine Wood (curves)
Do not attempt to remove the guard from
the machine.
Fitting a saw blade
Fig. B
The machine is equipped with a quick fit system.
• Turn the clamping ring (5) of the saw blade
holder as far to the left as possible and hold it
there.
• Place the saw blade in the blade holder.
• Let go of the clamping ring.
• Make sure when changing the saw blade that
the blade holder is free of material debris (such
as splinters of wood or metal).
• Before use, always check that the saw blade is
securely fixed.