Ferm AGM1063S, Original Instructions Manual

Page: 9 / 176

9
EN
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-4
Fig. A
1. Spindle lock button
2. Allen screw
3. Protection guard (Fig. D1+D2)
4. Carbon brush cover
5. On/Off switch
6. Side handle connection point
7. Side handle
17. Lock-off button
18. Allen key
Fig. B
8. Spindle
9. Mounting flange
10. Wheel disc (not included)
11. Clamping nut
12. Spanner
Fig. C1 & D1
Protection guard for grinding
Fig. C2 & D2
Protection guard for cutting (not included)
Fig. G
13. Screw
14. Spring
15. Carbon brush
16. Brush wire
Assembly
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the protection guard (Fig. C and D)
• Place the machine on a table with the spindle
(8) facing upwards.
• Place the protection guard (3) over the
machine head as shown in Figure C making
sure the ridges on the protection guard fall into
the notches of the machine head.
• Turn the protection guard counter clockwise as
shown in Figure D
• Fix the the allen screw (2) on the guard with the
allen key (18)
• You can adjust the position of the protection
guard by releasing the allen screw (2), adjust
the guard to the desired position and fixing the
allen screw again.
Never attempt to remove the guard.
Mounting and removing the disc (Fig. B)
• Always use suitable wheel disc for this
machine with diameter Ø 230 mm and a bore
from 22.2 mm the thickness of the wheel disc
should be 6 mm for wheel disc for grinding and
3 mm for wheel disc for cutting, the mounting
wheel disc may not touch the safety guard.
Mounting
• Place the machine on a table with the
protection guard (3) facing upwards.
• Mount the flange (9) onto the spindle (8).
• Place the wheel disc (10) onto the spindle (8).
• Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) onto the
spindle (8) by using the spanner (12).
Removing
• Place the machine on a table with the
protection guard (3) facing upwards.
• Keep the spindle lock button (1) pressed and
loosen the clamping nut (11) using the spanner
(12).
• Remove the wheel disc (10) from the spindle
(8).
• Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) using the
spanner (12).
Mounting the side handle (Fig. A and B)
• The side handle (7) can be screwed into one of
the three side handle connection point (6).