Ferlux AROA 10, Manual

Page: 26 / 48

26
6.2 MENÚ LEVEL 2
The functions that can be accesed in a submenu that is reached by long pressing (P3) and (P4) are known as
`MENU LEVEL 2´.
The functions of this submenu are as follows:
rAir: Regulation of the fan.
Cron: Timer to programme the heater to turn on and off.
orol: Clock.
TELE: Remote control.
rCLr: Cleaning reset.
TPAr: Technical menu.
When you push the (P3) and (P4) buttons at the same time, the first function of `menu level 2´will appear on the
upper display (D1). Using the (P2) or (P4) buttons, the user can move around and select the different functions.
Once the desired function has been chosen, click on the (P3) button. If you wish to return to the main screen, press the
(P1) button.
After around 40 seconds without any button being pressed, the display will return to the main screen.
6.2.1 [rAir] REGULATION OF THE FAN
This menu allows you adjust the power of the heating fan.
There are seven power levels above the default power level setting and seven levels below the default power level
setting.
To access the function ` rAir´ long press the (P3) and (P4) buttons until ` rAir´ , inmmediately after this, press
the (P3) button and figure `0´. Press the (P3) button again and the `0´ will flash. With the (P2) or (P4)
buttons, select the desired power for the fan, either faster or slower than the default power level setting.
6.2.2 [Cron] PROGRAMMING SCHEDULES
This function allows on/off times to be set for the heater.
This function has two sections, one to choose the scheduling mode that you wish to activate (ModE), and the other for
programming the schedules for each one of the modes (ProG).
In order to access this function, long press the
(P3) and (P4) buttons. ` rAir´ will appear on the upper display
(D1), then press the (P2) button and `Cron´ will appear, meaning that this function has now been accessed. Now,
immediately press the (P3) button, enter into the programming mode that was mentioned previously (ModE) or
(ProG), which can be navigated with the (P2) or (P4) button and then selected with (P3) button.