rated by comma. Without arguments, the command reloads all the subsystem.
Syntax:
reload[net|br|[work]|wlan|cfg|route|ac[cess]|class|frw|redir|snmp|system]
Example:
manager$ show eth0 ipaddr
ipaddr: 195.168.233.46
manager$ reload network
Important notice: Without executing the reload command, the changes will not be
effective.
reboot command
The reboot commands restarts the device similar to the hardware reset. It is required
for firmware downloads.
Syntax:
reboot
passwd command
The password command is used to change the login password. The command will
prompt the current one, and then ask the new password twice (for validation).
Example:
manager$ passwd
Changing password for admin
Old password:
Enter the new password (minimum of 5, maximum of 8 characters)
Please use a combination of upper and lower case letters and numbers.
New password:
Re-enter new password:
Password changed.
Remarks:
When prompted for „Old password“, „New password“ and „Re-enter new password“
input is not shown on the console (not even stars).
Default password is „admin“ and it is recommended to change it after login.
Setting IP addresses and netmasks
Setting the IP addresses and netmask is done via following set commands:
9
TRAFFIC MANAGER E-4000
