Ferax XAGD50/9040, Manual

Page: 15 / 28

11
ENGLISH
Original instructions
CONTENTS
1. Introduction ..........................................11
2. Technical specifications .......................11
3. Safety ...................................................11
4. Operating instructions ..........................11
5 Maintenance .........................................12
Spare parts list ...............................................19
EC conformity declaration ............................20
1. INTRODUCTION
Read the operating instructions care-
fully before using this device.
Familiarise yourself with its functions
and basic operation. Service the device as per
the instructions to ensure that it always fun-
ctions properly. The operating instructions and
the accompanying documentation must be kept
in the vicinity of the device.
2. TECHNICAL SPECIFICATIONS
Nail / Brad capacity ........Gauge 18; 15-50 mm
Fastener diameter ......................1.05 × 1.26 mm
Stapler capacity ..........5.7 mm crown Series 90
up to 40 mm length
Working pressure ............................60-120 PSI
Av. air requirement .............. 3 CFM / 85 lt / min
3. SAFETY
• When using compressed air always follow
the safety codes of practice laid out by the
compressor manufacturer.
• Damaged of split air hoses can cause a
”whip” hazard. Immediately replace dama-
ged air hoses.
• Ensure all air couplings are secure and tight.
• Do not try to modify the tool to accept faste -
ners other than those specified.
• Only use this equipment for its intended use.
Do not modify or change its design.
• When tool is not in use always disconnect
from the air supply
• Maintenance should only be carry out by a
competent person.
• Never point the nail gun at people or yourself
• When using this tool, safety clothing must
be worn. Goggles, gloves, ear defenders. Tie
back long hair and do not wear loose clo-
thing.
• Do not allow children to use this tool. Never
leave the tool connected to the air supply
before loading nails or staples.
4. OPERATING INSTRUCTIONS
• To load the magazine with nails or staples,
release the magazine by squeezing click
lever.
Fig. 1
• Insert fasteners into magazine. See over leaf
for details.
Then shut magazine by pushing full upwards.