Mode selection
With the flashlight off, press and hold the mode switch button for one second to temporarily enter into Strobe
mode. It will return to the general mode unless pressed.
With the flashlight on, a single press of the side mode switch button allows switching between
Turbo→Low→Mid→High→brightness levels. Press and hold the mode switch button for one second to enter
into Strobe mode. Press and hold the mode switch button again to return to the general mode.
RC10 memorizes the brightness level while in the general mode. When turned off and then on, the flashlight
automatically enters into the general mode.
Battery charging/
The RC10 has a low-voltage warning function. When voltage is checked, the flashlight enters the lower
brightness level; if low voltage is checked in the Low brightness level, it will blink three times per second
every five minutes. In this case, the battery should be charged or it will cause damage to the battery. To ensure
normal use, the flashlight will not turn off automatically until the battery protection function begins to work.
The built-in battery has the over-discharge protection function. When the voltage is extremely low, RC10 will
turn off automatically to protect the battery from over discharge. The function will not influence the normal
use.
When the charger is plugged into a household outlet, the indicator light will turn green. Put the flashlight into
the charger and rotate it until it clicks into position. The indicator light will now switch to red to indicate
charging has begun. When the indicator light returns to green, the charging cycle has been completed. The
charging time will be about 3 hours.
When the flashlight is on, please do not charge the battery. Or it will extend the charging time or it can not
charge fully. If it is needed urgently, it will still be ok to charge the battery with the flashlight on. However due
to the output protection function, RC10 can not enter into the Turbo in this case.
Note: The battery will discharge automatically, please charge the flashlight every four months to maintain the
maximum performance of the battery when RC10 is not used for a long time.
Usage and Maintenance
◎
Please don't disassemble the sealed head as doing so can cause damage to the flashlight and will void the
warranty.
◎
Due to the momentary-on tactical switch, the flashlight can be activated when stored, transported or placed
in a pocket. Unscrew the tail cap one-half turn or take out the battery to avoid unwanted operation.
◎
Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an
approved spare.
◎
Periodic cleaning of the battery contacts improves the flashlight’s performance as dirty contacts may cause
the RC10 to flicker, shine intermittently or even fail to illuminate for the following reasons:
Reason A: The battery lacks power.
Solution: Charge the battery.
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods don't work, please refer to the warranty policy before contacting your authorized
distributor.
Notice: The routine cleaning video can be watched and downloaded through the Fenix website by clicking on
the RC series followed by the maintenance tab.
Product Warranty
We will replace products with documented manufacturing defects within 15 days of purchase and repair a light
free of charge within 24 months of purchase if problems develop with normal use; if repair is required after 24
months from the date of purchase, we will charge for parts. The total repair fee is dictated by the cost of the
replaced materials.
Warranty Card Registration
We kindly suggest that you register your guarantee card on the official website of Fenixlight Limited. You’ll
receive an extra six months of warranty coverage once you have successfully registered. By participating in
an optional customer survey, you are entered in a drawing for free Fenix products.
Warning
