Fenix EPC1200, Operation Manual

Page: 34 / 56

EPC1200 SERIES OPERATION MANUAL
34/56
[Name] Select paper sensor(s) to output paper-end signals (PE in parallel interface)
[Format] ASCII ESC c 3
n
Hex 1B 63 33
n
Decimal 27 99 51
n
[Range] 0
≤
n
≤
255
[Description] Selects the paper sensor(s) to output paper end signals.
Each bit of
n
is used as follows:
Bit OFF / ON Hex Function
0 - - Undefined
1
OFF 00 Paper roll near-end sensor disabled
ON 02 Paper roll near-end sensor enabled
2
OFF 00 Paper roll end sensor disabled
ON 04 Paper roll end sensor enabled
3
OFF 00 Paper roll end sensor disabled
ON 08 Paper roll end sensor enabled
4-7 - - Undefined
[Notes]
•
The command is available only with a parallel interface and is ignored with a serial
interface.
•
It is possible to select multiple sensors to output signals. Then, if any of the
sensors detects a paper end, the paper end signal is output.
•
Sensor is switched when executing this command. The paper end signal switching
be delayed depending on the receive buffer state.
•
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper
sensor outputting paper-end signals
•
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper
sensor outputting paper-end signals.
•
When all the sensors are disabled, the paper end signal always outputs a paper
present status.
•
[Default]
n
= 12
ESC c 4 n
[Name] Select paper-near-end sensor to stop printing
[Format] ASCII ESC c 4
n
Hex 1B 63 34
n
Decimal 27 99 52
n
[Range] 0
≤
n
≤
255
[Description] Selects the paper-near-end sensor to stop printing when a paper-near-end is
detected, using
n
as follows:
Bit OFF / ON Hex Decimal Function
0 OFF 00 0 Undefined.
1 OFF 00 0 Paper roll near-end sensor disabled.
ON 02 2 Paper roll near-end sensor enabled.
2-7 - - - Undefined.
[Notes]
•
When a paper sensor is enabled with this command (n = 2), printing is
stopped.
[Default]
n
= 0
ESC c 5 n
[Name] Enable/disable the on-board button
[Format] ASCII ESC c 5
n
Hex 1B 63 35
n
Decimal 27 99 53
n
[Range] 0
≤
n
≤
255
[Description] Enables or disables the on-board button.