Fenix Imvico EPC1200 Series, Operation Manual

Page: 34 / 58

EPC1200 SERIES OPERATION MANUAL
34/58
3
OFF 00 Paper roll end sensor disabled
ON 08 Paper roll end sensor enabled
4-7 - - Undefined
[Notes] The command is available only with a parallel interface and is ignored with a serial
interface.
It is possible to select multiple sensors to output signals. Then, if any of the sensors
detects a paper end, the paper end signal is output.
Sensor is switched when executing this command. The paper end signal switching
be delayed depending on the receive buffer state.
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper
sensor outputting paper-end signals
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper
sensor outputting paper-end signals.
When all the sensors are disabled, the paper end signal always outputs a paper
present status.
[Default] n = 12
ESC c 4 n
[Name] Select paper-near-end sensor to stop printing
[Format] ASCII ESC c 4
n
Hex 1B 63 34
n
Decimal 27 99 52
n
[Range] 0
≤
n
≤
255
[Description] Selects the paper-near-end sensor to stop printing when a paper-near-end is
detected, using
n
as follows:
Bit OFF / ON Hex Decimal Function
0 OFF 00 0 Undefined.
1 OFF 00 0 Paper roll near-end sensor disabled.
ON 02 2 Paper roll near-end sensor enabled.
2-7 - - - Undefined.
[Notes] When a paper sensor is enabled with this command (n = 2), printing is stopped.
[Default]
n
= 0
ESC c 5 n
[Name] Enable/disable the on-board button
[Format] ASCII ESC c 5
n
Hex 1B 63 35
n
Decimal 27 99 53
n
[Range] 0
≤
n
≤
255
[Description] Enables or disables the on-board button.
When the LSB of
n
is 0, the on-board button is enabled.
When the LSB of
n
is 1, the on-board button is disabled.
[Notes] Only the lowest bit of
n
is valid.
[Default]
n
= 0
ESC d n
[Name] Print and feed
n
lines
[Format] ASCII ESC d
n
Hex 1B 64
n
Decimal 27 100
n
[Range] 0
≤
n
≤
255
[Description] Prints the data in the print buffer and feeds
n
character lines.
[Notes] This command sets the print starting position to the beginning of the line.
This command does not affect the line spacing set by
ESC 2
or
ESC 3
.
The maximum paper feed amount is 1016 mm {40”}. If the paper feed amount
(n x
line spacing) of more than 1016 mm {40”} is specified, the printer feeds the paper
only 1016 mm {40”}.
Every line feed corresponds to the current selected font height (24 dots for Font A
and 16 dots for Font B).
[Reference]
ESC 2, ESC 3.