FENDT varioguide, Operator'S Manual

Page: 108 / 158

Display
Signal lag Specifies the time in s taken to receive the correction signal update. If 999 is
shown here, the correction signal cannot be currently received.
Connection status Specifies the connection status of the GNSS receiver to the source of the
correction data (e.g. connected, update required, expired). The tick shows
whether the GNSS receiver is currently connected to the correction data
source.
Authorisation level Specifies the accuracy level of the GNSS receiver (depending on the hardware
modules installed in the receiver)
Signal format w
7.10.3 RTK network (external mobile radio modem)
7.10.3.1 Configure the external mobile modem correction signal
NOTE:
After the ignition has been switched OFF/ON, the system connects to the GSM/GPRS network
automatically and without further notice, provided that a connection was established before the ignition
was switched off. Please note that this action may result in data charges.
Procedure
1.
Select the RTK Network correction signal
under 'Signal Type'.
2.
Select the modem type "External modem"
3.
Enter the baud rate
4.
Select parity
5.
Select signal format
Fig. 56
7. Start-up
108 VarioGuide
438.020.070.012