GENERAL INFORMATION
Operator's Manual Combines FENDT 5270-6300- EN - LA327184015 - 11/2007
1-15
9.) When carrying out
welding
on the machine,
heat and welding splatters may cause serious
damage. If possible, have this work carried out
by skilled staff.
To prevent damage to the engine electronic
components, remove the specific
component from the combine and weld it
separately.
If the component cannot be removed,
proceed as follows:
a)
Stop the engine.
b)
Disconnect the negative cable from the
battery.
c)
Detach the ECU shield.
d)
Disconnect all of the harnesses from
the ECU.
e)
Tie up the harnesses to the machine so
that they cannot touch the ECU.
f)
Connect the welder ground cable as
close as possible to the area where the
welding is to be carried out.
g)
Protect hydraulic and electric
components exposed to welding
spatters.
10.) After any maintenance or repair work, collect
all tools used and store them in the toolbox on
the combine. Always check the combine for
loose parts, and ensure all guards have been
correctly reinstalled.
11.) Before starting the combine, make sure all
guards are fitted and that safety guards with
locks are properly secured.
These guards can be opened with a tool or with
the suitable key supplied with the ignition key.
Also check table, grain tank and sieves for
loose/disassembled parts.
¥
DANGER:
Risk of shocks, squeezing or
getting trapped.
Always sound the horn three times to warn
persons nearby of your intention to start
the engine.
12.) Before starting the engine, make sure no one is
carrying out service or inspection on the
machine or standing in the combine operating
range.
13.) Always keep children away from the combine.
14.) Check wheel nut torque after the first hours in
operation, as described in section
"PRELIMINARY SERVICE INSPECTION"
(page 4-2) and after any maintenance work
involving dismounting of wheels.
It is good
practice to check daily that the nuts have
not loosened or become defective in any
way.
¥
DANGER:
Risk of shocks, squeezing or
getting trapped.
15.) It is strictly forbidden to enter the grain tank
without stopping the engine and removing the
ignition key from the switch. Before inspecting,
cleaning, adjusting or servicing combine and
table (grain, maize etc.), always ensure that the
engine is stopped, the brakes are applied and
all moving parts have come to a complete stop.
¥
DANGER:
Risk of squeezing.
16.) Never work under the cutting table without
securing it firmly and/or engaging the safety
stops on the crop elevator lifting rams.
