GENERAL INFORMATION
1-14
Operator's Manual Combines FENDT 5270-6300- EN - LA327184015 - 11/2007
MAINTENANCE WORK
Work on the Machine
1.) Before inspecting, cleaning, adjusting or
servicing combine and table (grain or maize),
always ensure that the engine is stopped, the
brakes are applied and all moving parts have
come to a complete stop.
2.) To lift one side of the machine (for example to
remove a wheel), use lifting equipment with
suitable capacity, e.g. a column hydraulic jack
or a lift with a minimum capacity of 10,000 kg.
3.) Pay special attention while removing
preloaded parts.
¥
DANGER:
Risk of shocks.
It is strictly forbidden to loosen the nut
fastening the cylinder variator pulley
without using proper tools. This operation
may be carried out only by your Dealer's
skilled staff.
4.) Work on tyres requires correct tools and expert
knowledge.
An incorrect assembly can
seriously compromise your safety.
When in
doubt, refer to specialised staff.
5.) Before refitting the wheels, ensure that the
contact surfaces of wheel rim and final drive
hub are perfectly clean (remove paint); check
that the thread of bolts and nuts is in perfect
condition. The front wheel nuts must be
tightened to 550 Nm (56 kgm) crosswise and
the rear wheel nuts to 304 Nm (31 kgm).
Check that the nuts are sufficiently tightened
after the first working hours and then at least
every 80 hours. It is advisable to check, at least
once a day, that no parts are loose.
6.) Do not carry out any work (inspection or
maintenance) on the machine when the wheels
have been removed, unless the machine is
properly supported.
¥
DANGER:
Risk of high pressure fluid
splashes.
7.) The hydraulic, hydrostatic and diesel oil
injection systems can be pressurised.
Maintenance work on the systems may be
carried out only by specially trained staff.
8.) Before working on any part of the electrical
system, remove the battery ground cable or
switch off the main battery switch.
