Fema I3 Series, User Manual, Page: 6 / 12

F E MA · MANUFACTURING FOR INDUSTRIAL AUTOMATION 6
9. Access the ‘Configuration system’
Key ‘ SQ ’ (
<
)
‘ Configuration digits ’
Key ‘ UP ’ (
5
)
UP
SQ
‘CONFIGURATION SYSTEM’
• the ‘ configuration digits ’ indicate the active input signal range (see section 5)
• keys ‘ UP ’ (
5
) and ‘ SQ ’ (
<
) to configure the instrument (see section 10.2)
UP SQ
‘ Configuration digits ’
Opening the front cover reduces the security level. While front
cover is open :
• the isolation between accessible parts and power supply is
reduced from ‘ reinforced ’ to ‘ basic ’.
• accessible parts are part of the input signal circuit.
• operations must be performed by qualified operators.
When correctly connected, the input signal terminal prevents the
front cover from opening.
ACCESS THE ‘CONFIGURATION SYSTEM’
Step numbers as referenced at the image below.
1. Remove the input signal terminal
• make sure that there are no dangerous voltages at the output signal
terminals
2. Open the front cover
3. Configure the instrument
• locate the ‘ configuration digits ’
• locate the ‘ UP ’ (
5
) and ‘ SQ ’ (
<
) keys
BLOCK ACCESS TO THE ‘CONFIGURATION SYSTEM’
4. Close the front cover
• remove the input signal terminal (if it was placed)
5. Connect the input signal terminal
• when connected at place, check that the front cover can not be
opened
• if they were removed, connect the two output signal terminals
3
2
4
5 1