Fema B RTU Series, User Manual, Page: 28 / 36

FEMA ELECTRÓNICA . SERIES B . Models Bxx-RTU
28
1.23 Mounting
The instrument fixations are designed to allow panel mount,
wall mount, or hanging mount. For each type of mounting,
Side fixations
Fixation screws
Figure 8 - Panel mount
• Panel mount. Apply the cut-out to the panel as seen on
section
1.7.
Remove the side fixations. Introduce the in -
strument into the panel cut-out. Mount the side fixations
as shown
(see Figure 8).
Slightly loosen the fixation screw
of one side and press the instrument against the panel.
Tighten the fixation screw so it presses the panel and main -
tains the fixation. Repeat with the opposite side fixation.
Side fixations
Fixation screws
Diameter 4,5 mm
30 mm between
hole centers
Figure 9 - Hanging mount
Diameter 4,5 mm
30 mm between
hole centers
Side fixations
Fixation screws
Figure 10 - Wall mount
• Wall mount. Mount the side fixations against the wall,
as shown
(see Figure 10)
. Each fixation has 2 holes with
4,5 mm diameter and a separation between hole centers
of 30 mm. Once the side fixations are secured against the
wall, place the instrument and press the fixation screws
slightly. Tilt the instrument to the desired viewing angle
and firmly screw the fixation screws.
• Hanging mount. Mount the side fixations as shown
(see Fig -
ure 9)
. Each fixation has 2 holes with 4,5 mm diameter and
a separation between hole centers of 30 mm. Instrument
can be hanged using cable, threaded rod, ....
see the position of the fixations at the images below.