HOW TO INSTALL
1.
2.
3.
4.
5.
BOTTOM
TOP
Loosen grub screws on body of diverter
valve and remove the brass easy fit.
DIVERTER
VALVE &
INLET
A. Unscrew hose adaptor from bottom of the
column.
B. Fit slider ensuring the grub screws are
facing towards the ground. Secure hose
adaptor back onto column.
Note: Slider can be installed left or right
handed
C
-C
5
50
mm
Screw the top easy fit onto water outlet till it is
flush against the wall face.
A. With an allen key remove the two
grubscrews from the bottom mount to
remove the brass wall fitting. Keep these
grubscrews as they will be reused when
fixing the rail to the wall.
B. Install the brass wall fitting at the marked
center to center distance. Ensure that it is
vertically aligned with the water outlet fitting.
A.
B.
C
-C
5
50
mm
A.
B.
7.
Fit the wall mount into the
bottom slot on the back of the
rail as shown. Use a 5mm allen
key to tighten the internal screw
from the back until the wall
mount is fixed in place.
6.
From the supplied pack, loosely
fit the brass fitting and hex bolt
into the wall mount as shown.
Mark down vertical of 550mm from
centre of water outlet to bottom wall
fixing position.
Warning:
Ensure no water pipe or
power cable in wall at this location.