07
06
FLIP CHIPS
The Compulsion comes with two sets of pivot hardware for the Seatstay Yoke Pivot
to allow you to change the geometry of the bike. One set, called the “middle chips,”
is drilled with the pivot screw centered. This is the default geometry, as shown in
the geometry chart. The other set is called the “flip chips” and depending on the
orientation in which they are installed, they can raise or lower the BB height by 5mm
and steepen or slacken the head angle by 0.4° from the default geometry.
HEAD TUBE CABLE GUIDES
There are 3 interchangeable cable guides that fit the COMPULSION.
• Blanking plate (CCN096YB) This covers the
cable port when it is not used
• Two Hole 5mm x 3mm (CCN098YB) This port
fits a 4 or 5mm cable or hoses as well as a
E-tube wire.
• Two Hole 5mm (CCN099YB) This Cable port
fits two 4 or 5mm cables or hoses.
LOW SETTING
MIDDLE SETTING
HIGH SETTING
2019 Compulsion Series Supplement Manual_V6_21119.indd 6-7
2/11/19 9:20 AM
