3
12
DS-1200
C
LIMITED PRODUCT WARRANTY
TROUBLESHOOTING
Alternate slowly back and forth
Set to Reverse (R)
for 2-3 seconds
Set to Off (O)
and unplug
Gently pull uncut paper
from paper entry. Plug in
Set to Auto-On (I) and
resume shredding
1
2
3
4
5
6
PAPER JAM
ADVANCED PRODUCT FEATURES
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the
continuous operation and recovery time for this shredder.
SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
®
indicator will illuminate and the shredder will stop shredding.
PRODUCT MAINTENANCE
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
.
"MMDSPTTDVUTISFEEFSTSFRVJSFPJMGPSQFBLQFSGPSNBODF*GOPUPJMFEB
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Turn off and unplug
shredder
Locate Auto-start
infrared sensor
6TJOHDPUUPOTXBCXJQF
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
3
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
* Apply oil
across entry
Set to Off (O)
Set to Reverse (R)
2-3 seconds
12
DS-1200
C
2
1
3
1
12
DS-1200
C
4
12
DS-1200
C
2
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
additional costs incurred by Fellowes to provide parts or services outside of the country where the
TISFEEFSJTJOJUJBMMZTPMECZBOBVUIPSJ[FESFTFMMFS"/:*.1-*&%8"33"/5:*/$-6%*/(5)"50'
.&3$)"/5"#*-*5:03'*5/&44'03"1"35*$6-"3163104&*4)&3&#:-*.*5&%*/%63"5*0/
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
GPSBOZDPOTFRVFOUJBMPSJODJEFOUBMEBNBHFTBUUSJCVUBCMFUPUIJTQSPEVDU5IJTXBSSBOUZHJWFTZPV
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
FYDFQUXIFSFEJGGFSFOUMJNJUBUJPOTSFTUSJDUJPOTPSDPOEJUJPOTNBZCFSFRVJSFECZMPDBMMBX'PS
more details or to obtain service under this warranty, please contact us or your dealer.
SafeSense
®
Technology
Stops shredding immediately when
hands touch the paper opening.
12
12
3
SET-UP AND TESTING
Set to Auto-On (I)
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active
and working properly
1
2
For more information about all of Fellowes Advanced Product Features go to
www.fellowes.com
