BASIC SHREDDING OPERATION
1
PAPER/CARD
Plug in and put
disconnect power switch
in ON (I) position
Continuous operation:
Up to 5-minute maximum
NOTE:
Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 5-minutes will
trigger 20-minute cool down period.
Feed paper/card
straight into paper
entry and release
When finished shredding,
set to Off
2
4
Press Auto-On ( )
TROUBLESHOOTING
Shredder doesn’t start:
ATTENTION:
If the SafeSense
®
light remains on, you must engage the
Override Switch
in order to perform steps above.
Once the jam is cleared, reset the SafeSense
®
feature. (See SafeSense
®
instructions below.)
SafeSense
®
override switch
Active
Not active
Sensor light illuminated–
paper jammed
SafeSense
®
paper jam:
If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause the user to think the
shredder has jammed when it has not, use the
Override Switch
to deactivate the SafeSense
®
feature and clear the
paper.
Warning
– when switch is in override position, the SafeSense
®
light will flash and the SafeSense
®
feature will NOT
function. Once the paper is cleared, reset the SafeSense
®
feature.
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure control switch is in Auto-On
( ) position
Clear paper particles covering magnetic
safety interlock
Wait 20 minutes for red light to turn off
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY
Stops shredding immediately when hands touch the paper opening.
Touch test area
Sensor lights up
Press Auto-On ( )
SET-UP AND TESTING
3
2
1
1
PAPER JAM
Alternate slowly back and forth
Press and hold
Reverse (R)
2-3 seconds
Set to Off (O)
and unplug
Gently pull uncut
paper from paper
entry. Plug in
Press Auto-On
( )
and resume shredding
PRODUCT MAINTENANCE
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
.
"MMDSPTTDVUTISFEEFSTSFRVJSFPJMGPSQFBLQFSGPSNBODF*GOPUPJMFEB
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Turn off and unplug
shredder
Locate Auto-start
infrared sensor
Using cotton swab, wipe
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
3
Press and hold Reverse
(R) 2-3 seconds
* Apply oil
across entry
Set to Off
3
2
1
2
4
1
6
2
3
4
3
5
For more information about all of Fellowes Advanced Product Features go to
www.fellowes.com
1
3
