Page 10
Step #12: make any necessary adjustments
There are seven possible ways to change the position of the monitors to maximize the efficiency and comfort of the working environment. Refer to the
illustration on the following page.
1. Monitor position on slider
— To move the monitor from side-to-side, use the 2mm end of the dual Allen key to loosen the set screw (M4x9) on the bottom of the VESA mount assembly, then slide
the monitor along the slider bar. Do not loosen the set screw more than one full turn — the tip of the set screw must remain inside the groove on the slider bar so
that the mount assembly cannot slide off the ends. Re-tighten the set screw when the monitor is positioned where desired.
2. Monitor tilt
— Use the 4mm end of the dual Allen key
to loosen the screw on the side of the VESA mount to change monitor tilt angle. Tighten the screw to hold the angle.
3. Monitor swivel
— Use the 4mm end of the dual Allen key
to adjust the underside screw behind the VESA mount for the desired ease of monitor rotation.
4. Head adapter swivel (stubby monitor arm only)
— Use the 4mm end of the dual Allen key
to adjust the underside screw at the end of the arm stem for the desired ease of head adapter rotation. In effect, this is the
same as the monitor swivel adjustment.
5. Motion arm weight
— Use the 4mm end of the dual Allen key
to adjust the screw at the end of the motion arm for the appropriate monitor weight. When adjusted properly, the monitor
weight is balanced, making it easy to raise or lower the monitor.
6. Motion arm swivel
— Use the 4mm end of the dual Allen key
to adjust the screw in the underside of the fixed arm for the desired ease of motion arm rotation.
7. Fixed arm swivel
— Use the 4mm end of the dual Allen key
to adjust the underside screw at the end of the arm stem for the desired ease of fixed arm rotation.
KataEX3-FMS
Assembly
