Page 4
KataEX2-FF
Assembly
Step #2: install monitor arms
1.
Remove the locking ring from the connection sleeve. Rotate the locking ring counterclockwise to unlock it and then lift it off.
2.
Slide the connection sleeve onto the post with the screw toward the rear. With the sleeve at the desired height, tighten the screw using the 4mm Allen key.
3.
Install the monitor arm assemblies onto the connection sleeve by sliding their tabs into slots on the sleeve.
— The tabs of a monitor arm assembly can fit into any two adjacent slots on the sleeve. In the example below, the arm stems on the two monitor arm assemblies point
away from each other to form a 180° angle. In this case, there are two empty slots between the arm stems.
— For greater monitor projection, the arm stems can also be positioned so they form a 135° angle (one empty slot between arm stems) or a 90° angle (no empty slots
between arm stems). Because the fixed-fixed arm combination already provides large projection, the difference among the angles is rarely significant.
4.
Carefully cut the decorative covers to remove them from the set. Slide the covers into the unused slots on the connection sleeve.
5.
Lock the monitor arm to the connection sleeve with the locking ring. Rotate the locking ring clockwise to secure it.
Step #3: attach VESA plates to monitors
• Remove each VESA plate from its VESA mount by
(1)
pushing forward the tab at the top and
(2)
lifting upward.
—
TIP:
Practice re-installing the VESA plate before attaching it to the monitor. This will make step #4 easier.
• Place the monitor face down on a flat surface. Align the VESA plate holes with the holes on the back of the monitor. Attach the VESA plate using four of the provided
VESA plate screws.
— There are two sets of four holes on the VESA plates. One set has holes 3.9" (100mm) apart, the other set has holes 3" (75mm) apart. Use the set that matches the
holes on the rear of the monitor.
4mm
Allen
key
1
2
connection
sleeve
to unlock
turn locking ring
counterclockwise
lift off
slots
3
decorative covers
turn locking ring
clockwise to lock
4
5
tabs
90°
arm
stem
135°
180°
lift off VESA plate
VESA plate
screw
VESA
plate
monitor
(face down)
top
3.9"
(100mm)
3"
(75mm)
2
push tab forward
1
