9
WARNING:
Do not use on unsealed hardwood or unglazed ceramic
surfaces. For fl ooring in question, always test on a small inconspicuous area
before proceeding.
NOTE:
Before cleaning electrical appliances, check and follow appliance
manufacturer’s cleaning guidelines. Never apply to electrical parts.
NOTE:
Some delicate surfaces, such as painted wood or stainless steel may
be scratched or damaged by the Brass Utility Brush. Use careful judgment
when deciding what surface to clean with any of the brushes. If you are
unsure if a surface will be damaged, it is recommended that you test a
small inconspicuous spot before proceeding.
FILLING BOILER
1.
Place Canister Steam System on a fl at, level surface.
2.
Make sure illuminated On/Off Switch is turned to “Off” and grounded
power cord is unplugged from electrical outlet.
WARNING:
If unit has been in use, always use the following safety
precautions before removing the Boiler cap to add water:
•
Allow unit to cool for 20 minutes or until pressure gauge is at zero.
•
Press and hold Steam Trigger to release ALL remaining steam.
WARNING: Failure to follow these precautions may result in burns from
escaping steam when the Boiler Cap is removed.
3.
Cautiously unscrew and remove Boiler Cap.
WARNING:
Water may be hot.
4.
Drain any water remaining inside Boiler.
NOTE:
The Boiler should be emptied after each use – this will help minimize
mineral build-up and prevent over-fi lling.
5.
Using the Fill Cup, fi ll the unit with (1,890 ml) of water.
NOTE:
In order to signifi cantly reduce mineral build-up and prolong the life
of your Canister Steam System, use of distilled or de-mineralized water in
the unit is highly recommended.
WARNING:
Caution should always be used when pouring water into the
Boiler. Do not look directly down into fi ll hole when fi lling. Keep your free
hand and any children or pets at a safe distance.
6.
Replace Boiler Cap, ensuring that it is screwed on tightly to prevent hot
steam from escaping and causing injury.
GENERAL OPERATION
NOTE:
Be sure that Boiler has been fi lled and that all desired accessories are
connected before following these steps.
1.
For fi rst time use, remove protective plastic cover from electrical plug.
Plug power cord into a electrical outlet.
2.
Switch Lighted On/Off Switch to “On” position.
3.
Once 2 Bar (29 PSI) is reached, the unit is ready to begin steaming. At
