After proper installation, pair the xFOB and the xHUB as
described below. The xHUB remembers the 20 last paired
xFOBs. Pairing saves the ID of xFOBs in the memory of the
xHUB. Pairing is only done the first time you use an xFOB
with an xHUB. Remember, four xFOBs can be connected at
the same time. One as a STOP FOB, three as ALARM FOBs.
Pairing is only necessary the first time you
use your MOB+. Press and hold the button
on your xHUB.
HOLD 3 SEC
Immediately after releasing the button on
the xHUB, press and hold the button on your
xFOB.
HOLD 3 SEC
2
Release the button when the xHUB starts
flashing blue and gives a sound signal
indicating Pairing Mode.
BLUE LIGHT
The xHUB will give a sound signal and a
green light to indicate a successful pairing.
GREEN LIGHT
xFOB INITIAL PAIRING
IMPORTANT
We recommend that the installation of the MOB+
in your boat is performed by skilled personnel
familiar with electric wiring, or by a professional
mechanic or electrician. This is to prevent any
malfunction of the device related to installation.
The installation is simple and below you will
find a quick guide. See next page for wiring
instructions.
For more information, visit our website
www.fellmarine.com/support
YOUR ENGINE
Visit:
www.fellmarine.com/support
to find wire diagram for your
engine.
Connect the signal wires to the
existing kill switch wires and the
power wires to power.
YOUR ENGINE
Drill a 2-1/16” / 52mm hole in a
suitable place adjacent to the
drivers position.
2-1/16” / 52MM HOLE
Insert the xHUB to the pre-
drilled hole and tighten the nut.
MOUNT xHUB
Connect the cables and the
antenna to the xHUB.
CABLE & ANTENNA
!
Place the xHUB with the
antenna at least
~ 10” / 30cm from other
electronics equipment
transmitting EMI. The
antenna should be in as
free space as possible, but
where necessary it can be
bent up to 45 degrees.
1
INSTALLATION
IF YOU HAVE MULTIPLE ENGINES: SEE BELOW
MOBP17010
MOBP17011
INSTALLING MOB+ IN A METAL BOAT
If your helm is made out of conducting materials the wireless signals
from MOB+ may be degraded. The amount of signal degradation
experienced may vary from across boats and must be tested for each
case. If the signal is very poor you can install a separate external
antenna outside of your helm to increase the signal strength. Go to
www.fellmarine.com for more information.
DRILLING THE HOLE
The xHUB measures:
Ø=51,5mm / 2.03 in
Drill a 52mm / 2-1/16” hole
Be sure not to drill through any existing cables
or equipment mounted or situated on the
backside of your intended xHUB position!
MOBP17013
xFOB BATTERY
xHUB will indicate low battery on the xFOB by
blinking the light bar respective to the connected
xFOB. Change the battery within 15 hours when
the light bar blinks. FELL recommends using
Panasonic or Sony CR2032 coin cell batteries.
Battery Life:
300h Active Use
MOBP17014
Do not push with
force on the button
when inserting the
xHUB. This may cause
damage to the device.
1
2
© FELL Technology AS
Page 3/9
GENERAL USE AND INSTALLATION SECTION
MARCH 2018
REV200-0318
