FELIXprinters Quick Start Manual for the FELIX Pro 2
Page 27
FELIXprinters Quick Start Manual for the FELIX Pro 2
Filament Jam / Click to Reheat
The flow detection system is triggered – the printer moves to it’s idle position waiting for user action.
The flow detection system is triggered when there is no more filament going through the extruder or when the filament is not extruding at the
expected rate. Go to
www.felixprinters.com/support
to learn more.
Z-sensor triggered
The z-sensor triggered message should appear only when the tip of the hot-end touches the print bed.
If the message is displayed continuously go to
www.felixprinters.com/support
to find out how to solve this issue.
DEF error
Extruder: the sensor is defect or not connected properly. Please check if the connector is placed correctly and is clean on the inside.
Heated bed: please check if the bed is placed properly on all 3 magnet points.
DEC error
Extruder: the heater or sensor are giving improper values. Please check if the connector is placed correctly and is clean on the inside.
Heated bed: please check if the contact pins underneath the print bed are ok.
G32 leveling failed
The z-sensor triggered falsely during the leveling routine or measured probe values are out of their boundaries.
Go to
www.felixprinters.com/support
and look for the ‘z-sensor triggered’ topic.
5.4 Display messages
Chapter 5: Software, maintenance, support
Summary of Contents for FELIX Pro 2
Page 1: ...Quick Start Guide Pro 2...