www.felixprinters.com
Page
42
of
70
13.3
CONNECT ALL WIRES TO THE ELECTRONICS
BOARD.
We now will connect all the wires to the electronics board and make it
look like this
Step by step we will connect the wires to the board
All wires have to be screwed under a screw terminal. These are the steps:
- Cut the wire to length,
- Strip the wire ends approx. 5mm, like shown above. Not too long
because that could potentially cause a short circuit with other wires.
TIP: It is recommended to use cable-ties to form nice cable loops and get a
nice wiring job. You can remove excessive ones on the go
.
Mount the extruder motor like indicated above.
Do this for the rest of the motor wires. Note the cable ties.
Take the wires of the x-axis opto-sensor, strip the ends.
Mount it as indicated above.
Extr
Z
Y
X