
www.felixprinters.com
Page
24
of
70
10
MODULE 3: THE X-AXIS (TIME: 30-60 MIN.)
Note: Don’t waste any belt. There is only one long belt in the kit, which must be divided in such a way that it is usable for the x and y-axis.
BOM x-axis
Part description
Amount
x-stage-motor-bracket_v6_F1_5
1
x-axis belt mount_v6_F1_5
1
Hiwin lineair ball bearing set
1
pulley_motor_HTD
1
motor nema 17
1
bearing 624
1
optosensor
1
IMPORTANT: DO NOT let the cart of the linear
bearing go off the rail. There are small balls in there
which might fall out when the cart rolls of the rail.
Put the frame
upside down
. Mount the hiwin rail loosely onto the
beam. Use 2 black t-slot nuts with m3 holes in them with m3x12 bolts to
mount the rail. Also place a m4 t-slot nut as indicated in the picture above,
that one will be used for the x-axis belt mount part.
Pre-assemble the x-axis belt mount part. From right to left.
M4x40 bolt, small washer, plastic part, large washer, 2x small washer,
bearing, 2x small washer, large washer, plastic part.