www.felixprinters.com
Page
4
of
70
2
INTRODUCTION
First of all thank you choosing FELIXprinters! To get your Felix printer up and running as fast
and painless as possible please follow this manual carefully. When things are unclear or if you
have any remarks or tips, please contact us at
. We also recommend
looking on our forum and get yourself a forum account. You will benefit from the ability to get
downloadable and printable upgrades for your printer. Also it is a great source to obtain more
knowledge about your printer and printing in general.
Depending on your skills this kit will take approximately 4-12 hours to assemble and to make
your first print. Please read the manual carefully and follow it step by step. Please don’t make
any shortcuts unless you know what you’re doing. It’s better to spend a few minutes extra on
reading, than to wait a week for new parts.
The manual is build up as follows: Each module starts with a short introduction. After that a Bill
of Materials (BOM) is presented. The BOM doesn’t contain the small bolts and nuts, because for
the assembly of the printer the assortment box of bolts and nuts is required. Further to not bloat
the manual, a picture of each part is only displayed in the complete BOM of the printer. This can
be found in the Supplement at the end of the manual.
Before starting the build of your printer, it’s recommended to check if all parts are present by
comparing it with the bill of materials.