Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com
Page
29
of
51
Mount the small
y-stage bracket pt4_v4 onto the y-stage bracket
pt2_v5_F1_5. Use a m4x25 bolt and a m4 nut. This small part is
needed to tension the belt later on.
Get the small aluminum beam, first put the plastic cap on it, next to the
drilled hole. This can be done with a hammer.
Slide in the small t-slot nut on the other side, and mount this beam
onto one of the middle 2 holes of the y-axis rail with a M3x8 bolt.
Take the table assembly and place the m4x30 countersunk bolts as
indicated above on the three holes in the table. Put a curved washer,
large washer and fix those with a m4 thin nut.
On top of the just mounted washers place per each bolt, 5 large
washers and 4 curved washers.
