Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com
Page
22
of
51
9
MODULE 3: THE X-AXIS (TIME: 30-60 MIN.)
Note: Don’t waste any belt. There is only one long belt in the kit, which must be divided in such a way that it is usable for the x and y-axis.
BOM x-axis
Part description
Amount
x-stage-motor-bracket_v6_F1_5
1
x-axis belt mount_v6_F1_5
1
Hiwin lineair ball bearing set
1
pulley_motor_HTD
1
motor nema 17
1
bearing 624
1
optosensor
1
IMPORTANT: DO NOT let the cart of the linear
bearing go off the rail. There are small balls in there
which might fall out when the cart rolls of the rail.
Put the frame
upside down
. Mount the hiwin rail loosely onto
the beam. Use 2 black t-slot nuts with m3 holes in them with m3x12
bolts to mount the rail. Also place a m4 t-slot nut as indicated in the
picture above, that one will be used for the x-axis belt mount part.
Pre-assemble the x-axis belt mount part. From right to left.
M4x40 bolt, small washer, plastic part, large washer, 2x small washer,
bearing, 2x small washer, large washer, plastic part.
IMPORTANT MOUNT THE BELT BEFORE MOUNTING THE BRACKET
SHOWN ABOVE:
Guide the belt over the bearing as shown above
before mounting the sub-assembly to the frame. The top-bolt in the
picture is an m4x16 bolt, also use a washer.
Mount bolt loosely,
make sure plastic
doesn’t deform
Mount belt
before
mounting
bracket onto
frame.
