7
JOINTER SAFETY WARNINGS
•
Disc cutters must be rated for at least the speed recommended on the tool
.
Disc cutters
running over rated speed can fly apart and cause injury.
•
Always use the guard.
The guard protects the operator from broken disc cutter fragments and
unintentional contact with the disc cutter.
BRIEF DESCRIPTION
The Felisatti RF100/710 biscuit joiner is intended solely for cutting slots for biscuits in solid wood and
wood related materials such as MDF, particle board, plywood, etc. Any alternative use of this
machine would be considered a failure to comply with the intended purpose of the machine. The
manufacturer is not liable for any damage or injury arising from the improper use of this machine and
the user assumes sole responsibility in this case.
DOUBLE INSULATION
To ensure safer operation of this tool, Felisatti has adopted a double insulation design. "Double
Insulation" means that two physically separated insulation systems have been used to insulate the
electrically conductive materials connected to the power supply from the outer frame handled by the
operator.
To keep the double insulation system effective, follow these precautions:
• Be careful not to pierce the motor housing as this could damage the efficiency of the double
insulation system.
• Only Felisatti Authorized Service Centers should disassemble or assemble this power tool, and only
genuine Felisatti replacement parts should be installed.
EXTENSION CORDS
Make sure your extension cords are in good condition. Make sure you use an extension cord that is
heavy enough to carry the current your tool requires. An undersized cord will cause a drop in voltage
which creates a loss of power and could cause your tool to overheat. Please utilize the table below to
identify the proper gauge cord for the tool you are using. Remember, the lower the number, the
heavier gauge the cord. If you are unsure as to which gauge cord you need, use the next heavier
gauge.
Summary of Contents for RF100/710
Page 53: ......
