11
CHANGING THE BLADE
Be careful, the teeth on the blade are sharp
and can cause injury.
Remove the top flange, blade and lower flange
completely and clean any sawdust and resin from
the spindle, blade flanges, blade housing and slide
tracks.
Fig.1C
Ensure that the lower flange and blade seat
correctly before fitting the top flange.
Ensure that the blade is fitted the correct
way up.
Fit the top flange, check that it seats correctly and
finger tighten. Fully tighten the flange using the pin
wrench and locking spindle with spindle lock button.
Lightly oil the slide assembly using the plastic
lubricating bottle supplied (use a thin machine oil to
refill the bottle when empty).
Replace the plastic end cap and tighten the two
screws.
Use the spring release / locating hook to refit the
two springs.
Fig. 1C
USING THE DUST BAG - Fig. 2
1. To attach the Dust Bag (R), fit it over the nozzle
of the Dust Exhaust Tube (P) on the joiner
2. To empty the dust bag, first turn off and
disconnect the machine from its power source
Remove the dust bag from the exhaust tube and
unzip the bag to empty the sawdust
Fig. 2
ADJUSTING THE DEPTH OF CUT
The machine is preset to cut at 6 different depths
Setting on Plunge
Depth Stop
0 10 20 A B
Max
Biscuit Size
0
10
20
N/A
N/A
N/A
Depth of Cut
5/ 6”
8mm
13/32”
10.4mm
15/32”
11.9mm
1/2”
12.7mm
19/32”
15mm
25/32”
19.9mm
Width of Cut
2 5/32”
54.8mm
2 3/8”
60.4mm
2 9/ 6”
65.2mm
2 2 /32”
67.5mm
2 3/ 6”
71.4mm
2 29/32”
73.8mm
Summary of Contents for RF100/710
Page 53: ......
