Felisatti PF82/900M, Operating Instructions Manual

Page: 8 / 69

3. Before installing a new toothed belt, thoroughly clean
pulley G and drive wheel E .
4. Install the new toothed belt on drive wheel E and
press it in place, while rotating large pulley G at the
same time.
5. Replace toothed belt cover Q and fix it in place with
screw R .
MAINTENANCE AND CARE
WARNING! Always unplug the machine before carrying
out work on it.
-
Blade inspection: Excessive forward movement will
significantly reduce machine power and blade life.
Sharp blades will permit a high cutting capability and
increase machine life. Blades should be replaced ac-
cording to requirements.
-
Inspect the mounting screws: regularly inspect all
the mounting screws and ensure they are firmly tight-
ened. Should any screw be loose, tighten it immediate-
ly. Failure to do so could put you at serious risk.
-
Motor maintenance: always take the greatest care
over this and make sure that the motor winding is not
damaged and does not become wet with oil or water.
-
The vents should always be kept clean and free of
obstacles.
-
Clean the machine thoroughly after each use. Blast the
motor regularly with compressed air.
-
Check that the mains lead is in good condition. If it is
not, take it to an Official Service Centre to have it
replaced.
-
Brush replacement: brushes must be replaced
when length reaches 8 mm or less. To do so, please
contact an authorized after sales service centre. We
recommend that every other time you take a tool to
an after sales service centre for carbon brushes re-
placement you also order a general maintenance
(cleaning and lubrication).
-
Use only Felisatti accessories and spares. Parts the
changing of which is not covered in this instruction
manual, should be replaced in a
Felisatti Official Ser-
vice Centre.
WARRANTY
See general warranty conditions printed on the attached
sheet.
Do not dispose of electric tools in
the household waste!
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.