NOTE:
Make sure the battery and battery charger are lined up correctly. If the battery does not slide
onto the battery charger easily, don’t force it. Instead, remove the battery, check that the top of battery
and the battery charger slot are clean and undamaged and that the contacts are not bent.
3.
A flashing green light and a steady red light indicate the battery is charging
.
4.
Both steady green and red lights indicate the battery is fully charged.
WARNING:
Always be sure that the tool is switched off and the battery cartridge is removed prior
to any service work on the power tool.
Installing or Removing Battery
CAUTION:
Always switch off the tool before installing or removing the battery. Hold the tool and the
battery firmly when installing or removing the battery cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip out of your hands and may result in damage to the tool and
battery cartridge and cause personal injury.
To remove the battery cartridge, slide it from the tool while pressing the button on the front of the
cartridge.
To install the battery cartridge, align the tongue on the battery cartridge with the groove in the
housing and slip it into place. Insert it all the way until it locks in place with an audible click.
CAUTION:
Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not
being inserted correctly.
NOTE:
Pressing the button on the Battery will indicate the charge level. The right LED indicates a
high charge level and the left a low charge level that indicates the battery pack will require charging soon.
IMPORTANT:
When a low charge level is indicated, the tool may stop operating while in use, which
is
dangerous. Always ensure the battery pack has a good charge level.
NOTE:
Remove
the battery from the battery charger when the battery is fully
charged or when the
charger is disconnected
from the supply.
The battery will not accept a charge if the battery temperature is too high. In that case, the Red light
flashes until the battery cools down to normal temperature.
The battery will not accept a charge if the battery is damaged. In that case, Both the Red and Green LED
will flash. It indicates that the battery is bad and needs to be replaced.
Assembly
7