76
77
A
B
!
"
!
"
#
$
A
B
! "
Saw-Spindle Moulder
B3
Saw-Spindle Moulder
B3
11.7 Adjusting/correcting the parallel cutting fence angle
Required tools
• 2 Spanners 13 mm
Fig. 108: Check the parallel cutting fence guide angle
Fig. 109: Readjust the parallel cutting fence guide angle
1.
Switch the machine off and ensure that it cannot be
switched on again.
2.
Check the guide angle and readjust if required.
3.
Remove the guide.
4.
Pivot the parallel cutting fence outwards.
5.
Adjusting in the „A“ direction:
• Hold the screw tight with the spanner.
• Loosen the inner nut with a spanner.
• Unscrew the screw by half a turn.
• Tighten the inner nut.
6.
Adjusting in the „B“ direction:
• Hold the screw tight with the spanner.
• Loosen the inner nut with a spanner.
• Unscrew the screw by half a turn.
• Tighten the inner nut.
7.
Assemble the guide.
8.
Pivot the parallel cutting fence back.
9.
Check the adjustment of the angle with a bevelled
steel square and readjust if required.
!
Guide
"
Parallel cutting fence
#
Screw
$
Screw
Faults
11.8 Adjusting the locking force of the parallel cutting fence
Attention! Risk of material damage! Only adjust if the clamping force of the parallel cutting fence is not
sufficient. If the clamping force is too great, it will damage the parallel cutting fence and the fence hou-
sing.
Fig. 110: Adjusting the locking force of the parallel cutting fence
1.
Switch the machine off and ensure that it cannot be
switched on again.
2.
Hold the inner nut tight with a spanner.
3.
Loosen the lock nut with a spanner.
4.
Turn the inner nut half a turn anti-clockwise.
5.
Tighten the lock nut.
6.
Check the clamping force and adjust if necessary.
!
Nut
"
Lock nut
