25
!
"
!
!
Bandsaw
FB 510/610/710 & FB 710 c-tech
Attention!
In order to prevent sparks being generated, it is recommended that Super Glide (article number 10.0.010)
is used on a regular basis (sprayed on to the guides).
The bandsaw has an On- and Off switch.
Green push button:
Switch machine on
Red push button:
Switch off the machine.
!
Green push button
"
Red push button
7.7 Authorised working techniques
All uses which differ from the following work techniques
have not been intended for this machine and are therefore
not authorised.
Feed the workpiece with constant speed and pressure for-
wards without applying sideways pressure. Do not interrupt
the cut and do not pull the workpiece backwards. When
cutting large pieces, use appropriate table extensions or
roll supports.
Fig. 7-8: Rip cut
7.7.1 Longitudinal cut along the marked line
Warning! Risk of injury due to insufficient preparation!
It is only permitted to switch on the machine if, for the work at hand, the required preconditions are
fulfilled and any preliminary work is completed. Therefore, the adjusting, fitting and operating instructions
(see the corresponding chapters) must be read before switching on the machine.
Fig. 7-7: On- and Off switch
Attention! The machine will not start with the doors open and will automatically stop if doors are opened
during operation. (Only valid for the CE-version !)
7.6 Switching on the machine / Switching off the machine
Operation
Attention!:
The machine may not be switched off more often than 15 times per hour using the red Off switch.
The frequency converter will become too hot and it could result in an error message. In this case, the ma-
chine will come to a rest without slowing down!
