FEISHEN K550ATV EEC 4x4, Owner'S Manual, Page: 63 / 102

Battery Removal
1. Disconnect the hold-down strap holding the electrical box and battery in position,
and remove battery cover.
2. Remove the battery vent tube from the battery.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red (positive) battery cable next.
5. Lift the battery out of the ATV. Being careful not to tip it sideways, which could
spill electrolyte.
CAUTION
If electrolyte spills, immediately wash it off with a solution of one tablespoon baking
soda and one cup water to prevent damage to the ATV.
Battery Installation and Connections
WARNING
To avoid the possibility of explosion, always connect battery cables in the order
specified. Red (positive) cable first; black (negative) cable last. An exploding battery
can cause serious injury or death.
Battery terminals and connections should be kept free of corrosion.
If cleaning is necessary, remove the corrosion with a stiff wire brush. Wash with a
solution of one tablespoon baking soda and one cup water. Rinse well with tap water
and dry off with clean rags. Coat the terminals with dielectric grease or petroleum
jelly. Be careful not to allow cleaning solution or tap water into the battery.