20
WSB 20-180 / WSB 20-230 / WSB 25-180 X / WSB 25-230 X
EN
➤
Completely unscrew the clamping
unit (3) by hand.
➤
Change the used accessory or insert a
new one.
➤
Screw in the clamping unit (3). Tighten
the clamping unit tightly by hand until
notching is audible.
➤
Swivel the quick-clamping lever (2) back
until it engages.
Securing the work piece.
➤
Secure the workpiece adequately.
A
workpiece that is not properly secured
can, for example, cause the accessory to jam and
kick back, fall and cause other hazards.
General operating instructions.
Switching ON and OFF (Figure 1).
First check that the mains supply lead and
mains plug are not damaged.
The power tool only starts when the grip (6) is
notched.
Switching ON:
➤
Press the switch (1a) and the lock-
off (1b) at the same time.
Switching OFF:
➤
Let go of the switch (1a).
Locking the switch:
➤
Keep the switching on lock (1b) pressed
while the power tool is switched on, and
let go of the switch (1a).
➤
To unlock, press the switch (1a) once
again and then let go of it.
The angle grinder starts gently and reaches
its working speed after a short time.
The
self-start prevention lock
prevents the angle
grinder from starting again on its own accord if
the current supply has been interrupted during
operation, even if only for a short time, e.g. by
pulling out the mains plug.
➤
Apply the power tool to the workpiece.
Conduct the mains lead away from the rotat-
ing wheel.
If you lose control over the
power tool, the mains lead could be cut through
or caught, thereby drawing your hand or your
arm into the rotating wheel.
Use a high speed for grinding or cutting
operations.
Do not strain the power tool!
Please note:
The
electronic braking system, EBS
,
gradually initiates the braking effect after a short
delay when the power tool slows down, and
stops the accessory within a few seconds.
In the case of a power cut during operation, or
if the mains plug is pulled out during operation,
the accessory slows down without braking.
Grinding:
➤
Keep to an angle of tilt of 20 – 40°. In
this way you will obtain a good removal.
➤
Press the power tool on evenly and
move it over the surface.
Do not allow the surface of the workpiece
to become too hot.
Cutting:
➤
Always work against the direction of
rotation so that the cutting wheel does not
jump out of the cut.
3 41 01 020 06 3.book Seite 20 Dienstag, 10. Mai 2005 11:34 11
