22
en
Changing the tool.
Before mounting or replacing application tools or accessories, remove the
battery.
This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Mounting a grinding disc (figure 7).
Press the locking button only when the
motor is stopped.
Press the locking button completely through
and hold it in place.
Loosen the quick-
clamping nut.
Unscrew the quick-clamping nut.
Replace the used-up grinding accessory
or insert a new one.
Pay attention that the grinding acces-
sory is properly centered between the
support flange and the quick-clamping
nut.
WARNING
1.
2.
Fig. 7
Quick-clamping
nut
ACCURATE
ACCURATE
2.
3.
3.
1.
1.
4.
4.
4.
4.
3.
3.
3.
Manually screw on the quick-clamping nut
again.
Press the locking button completely through
and hold it in place.
T
ighten the quick-
clamping nu
t
.
Note:
Observe the mounting direction of
the quick-clamping nut.
Before each use, tighten the application
tool firmly.
Offset grinding discs must be mounted in
such a manner that their grinding surface is
2 mm below the bottom edge of the wheel
guard.
Grinding accessories that do not
meet these requirements cannot be ade-
quately covered off and are not permitted.
Summary of Contents for CCG18-125-10 AS
