Fein BOP6, Manual

Page: 15 / 156

15
en
For your safety.
Read all safety warnings and all
instructions.
Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed “General
Safety Instructions” (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
hand-held drill for drilling in metal, wood, plastic,
ceramics, and for tapping in weather-protected envi-
ronments using the application tools and accessories
recommended by FEIN.
The hand-held drill is not intended for working carbon
fibre reinforced plastics.
This power tool is also suitable for use with AC gener-
ators with sufficient power output that correspond to
the Standard ISO 8528, design type G2. This Standard
is particularly not complied with when the so-called dis-
tortion factor exceeds 10 %. When in doubt, please
refer to the generator instruction/specification guide.
Safety warnings for drills.
Safety instructions for all operations.
Use the additional handle (s). Loss of control can lead
to injury.
Character Unit of measure-
ment, international Unit of measure-
ment, national Explanation
P
1
W W Power input
P
2
W W Output
U
V V Rated voltage
f
Hz Hz Frequency
n
0
/min, min
-1
, rpm,
r/min
rpm No-load speed
n
1
/min, min
-1
, rpm,
r/min
rpm Speed, full load
M...
mm mm Size of metric thread
Ø mm mm Diameter of a round part
mm mm Max. capacity in steel with up to 400 N/mm
2
–
high speed steel (twist drill bit)
mm mm Max. capacity in aluminium with up to
300 N/mm
2
– High speed steel (twist drill bit)
mm mm Max. drilling diameter in wood (twist drill bit)
mm mm Tap
mm mm d1 = Clamping range of drill chuck
d2 = Thread size of shaft
(WBP 10 (**): Taper ISO 239 on drilling shaft)
d3 = Collar diameter
kg kg Weight according to EPTA-Procedure 01
T
a
°C °C Allowable ambient temperature
L
pA
dB dB Sound pressure level
L
wA
dB dB Sound power level
L
pCpeak
dB dB Peak sound pressure level
K... Uncertainty
m/s
2
m/s
2
Vibrational emission value according to
EN 62841 (vector sum of three directions)
h,D
m/s
2
m/s
2
Mean vibrational value for drilling in metal
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
Basic and derived units of measurement from
the international system of units
SI .
Fe
Al
WARNING