5
en
Special safety instructions.
Use auxiliary handle(s), if supplied with the
tool.
Loss of control can cause personal
injury.
Wear personal protective equipment.
Depending on application, use a face shield,
safety goggles or safety glasses. As appro-
priate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stop-
ping small abrasive or work piece frag-
ments.
The eye protection must be capable
of stopping flying debris generated by vari-
ous operations. The dust mask or respirator
must be capable of filtrating particles gener-
ated by your operation. Prolonged expo-
sure to high intensity noise may cause
hearing loss.
The application tools are sharp. Never place
your hand near the application tools.
Touch-
ing application tools can lead to injuries.
When working at height, secure the work
area and the area below it from falling chips
and the power tool itself.
Falling objects can
lead to injuries.
Secure the work piece firmly.
A work piece
that is gripped tightly in a clamping device or
vice, is more secure than if held by hand.
Do not rivet or screw any name-plates or
signs onto the power tool.
If the insulation is
damaged, protection against an electric
shock will be ineffective.
Do not use accessories which are not specif-
ically designed and recommended by the
power tool manufacturer.
Safe operation is
not ensured merely because an accessory
fits your power tool.
Clean the ventilation openings on the power
tool at regular intervals using non-metal
tools.
The blower of the motor draws dust
into the housing. An excessive accumulation
of metallic dust can cause an electrical haz-
ard.
Before putting into operation, check the
power connection and the power plug for
damage.
Recommendation: The tool should always be
supplied with power via a ground fault cir-
cuit interrupter (GFCI) with a rated current
of 30 mA or less.
